![iptrace command windows iptrace command windows](https://help.edovia.com/hc/article_attachments/360003323874/find-ip-windows.png)
Traceroute, also referred to as tracert on Windows operating systems and. The following example specifies that the traceroute starts at a user-specified source IP address of 172.20.22.31 to a destination IP address of 10.25.2.10. The Traceroute online tool traces the whole route of a network request from our. Hop is a location where packets stop while reaching the destination. TRACERT (Traceroot Utility) uses varying IP Time-To-Live (TTL) values.
![iptrace command windows iptrace command windows](https://www.itechtics.com/wp-content/uploads/2019/08/ipconfig.jpg)
The following example specifies that the wait for a response timeout is 4 seconds. Windows Traceroute command-line utility is used to trace a route of the network by sending ICMP (Internet Control Message Protocol) packets to the network destination.
![iptrace command windows iptrace command windows](https://wtmatter.com/wp-content/uploads/2019/11/ipconfig-command-to-find-ip-address.png)
The following example specifies that the traceroute command is issued to the IP address over the user-specified network interface private and VLAN 123. Just like the ping command, tracert sends also ICMP echo packets to the destination with varying Time-to-Live (TTL) values. The first three probe packets reach the host at 172.44.0.1 in times ranging from less than one to a little over two milliseconds. The command traces the path that a TCP/IP packet takes towards a destination target and shows some information (if available) of the routing nodes within this path. As you can see, I've done a tracert to PDQ.com. To use tracert, simply open up either Command Prompt or PowerShell and type in the command tracert followed by a hostname or destination IP address. The following example traces the route to IP address 172.30.0.167, identifying each host in the route and the amount of time that it takes for each of three probe packets to travel to each host. So let's take a look at an example and break it down.